Easy, assuming your handle gives 4 degrees per rev.
Count and choose a 30 hole that will do multiples of 4 degrees ie 4,8,12,16,20,24,28,32,36,40,44,48,52 etc
Set the pin to drop in on that pcd
Set RT to zero and dividing plate drop in to nearest notch, more than likely wont line up.
18 revs of your handle from here would be 72 degrees, drop in to same hole as was zero.
Dont worry if 72 degrees doesnt line up on RT, just treat as a guide.
Lock the table job done.
Next 72 degrees is 15 revs of your handle, just spin round until near 144 degrees and drop pin in zero hole.
Told you its easy.
Most of my stuff is multiples of 6 and 12 with a few variations once figured out. I do from zero size to around 10" swing.



