« previous next »
Pages: [1]   Go Down

Author Topic: United States Manufacturing “MV”  (Read 3498 times)

Offline nel2lar

  • Jr. Member
  • **
  • Posts: 81
United States Manufacturing “MV”
« on: November 04, 2012, 10:49:57 PM »
Looking for someone that has a Model MV. I need some dimension on the pulleys. My machine had a 3 phase VFD and I did not have the controller or the the 3 phase line at home. I will be running 22oV single phase. Any help would be appreciated. Thanks again
Nelson Collar   
Logged

Offline nel2lar

  • Jr. Member
  • **
  • Posts: 81
Re: United States Manufacturing “MV”
« Reply #1 on: November 06, 2012, 09:31:25 PM »
Looking for someone that has a Mill Rite Model MV Horizontal Milling Machine. What I am looking for is dimension of the two pulleys. My machine had a single speed drive because the company that owned it had a air over hydraulic system and I wanted it for anything I put on it. If any one had all I need is the diameters of the pulleys.

Nelson Collar   
Logged

Offline AR1911

  • Jr. Member
  • **
  • Posts: 47
Re: United States Manufacturing “MV”
« Reply #2 on: November 30, 2012, 05:55:18 PM »
Nelson, I think I promised you i would measure those pulleys, then lost your message, or forgot where you PM'd me perhaps..
If you will email me directly that would help.
My email is in my profile
Logged
Pages: [1]   Go Up
« previous next »