| Gallery, Projects and General > How do I?? |
| How do i go about turning a crown on a idler wheel. |
| << < (2/4) > >> |
| Rob.Wilson:
What i have done in the past , is mount job on mandrel between centres , so there is plenty of room to work, remove tool post , mount tool further back and with the top slide nuts just slack enough for it to move freely, then working it from side to side ,feeding in with the cross slide , but the job must be small enough to clear the top slide . Rob |
| BillTodd:
May not be suitable for your lathe but might provide some inspiration: |
| Rob.Wilson:
Now thats a clever use of a TTA Bill , my Myford one could be adapted very easily to that setup . I will remember that one . Rob |
| NeoTech:
nice, gonna do a dry run for both of those setups by turning som blanks in hardwood or something. =) thanks! =) |
| Rob.Wilson:
Don't forget to show how you got on :poke: Rob |
| Navigation |
| Message Index |
| Next page |
| Previous page |