| Gallery, Projects and General > How do I?? |
| How do i go about turning a crown on a idler wheel. |
| (1/4) > >> |
| NeoTech:
For a belt grinder.. It needs a 2degree crown it states in my description.. i have no frickin idea how to make it though and smooth. have no radii turner attachment either. :| |
| Rob.Wilson:
How wide 20mm or 100mm ? What sort of lathe do you have ? Me i would just make a rad attachment to do the job :dremel: then its always there if you need it for future projects :med: Rob |
| NeoTech:
Its a 60mm wide wheel of 100mm in diameter. And uhm i have Optimum 320x920 ( http://www.roughedge.se/blogg/wp-content/uploads/2011/12/k%C3%A4llare4.jpg ) I got this far |
| Rob.Wilson:
Ok , much better with more info Andreas :poke: is your lathe top slide free to rotate 360 Deg ? Rob |
| NeoTech:
its a hinge pin on the topslide, a big bolt more or less. on that ive mounted the multifix holder. But the topslide it self can be set to a degree, by loosing 2 bolts.. i dont think it will freely rotate a full turn if i remember correctly the topslide have the 2 bolts sitting in two circular slots. |
| Navigation |
| Message Index |
| Next page |