Gallery, Projects and General > How do I??

How do i go about turning a crown on a idler wheel.

(1/4) > >>

NeoTech:
For a belt grinder.. It needs a 2degree crown it states in my description.. i have no frickin idea how to make it though and smooth. have no radii turner attachment either.  :|

Rob.Wilson:
How wide 20mm or 100mm ?

What sort of lathe do you have ?


Me i would just make a rad attachment  to do the job :dremel:  then its always there if you need it for future projects  :med:


Rob

NeoTech:
Its a 60mm wide wheel of 100mm in diameter.

And uhm i have Optimum 320x920 ( http://www.roughedge.se/blogg/wp-content/uploads/2011/12/k%C3%A4llare4.jpg )

I got this far

Rob.Wilson:
Ok , much better with more info Andreas  :poke:

 is  your lathe top slide free to rotate 360 Deg ?


Rob

NeoTech:
its a hinge pin on the topslide, a big bolt more or less. on that ive mounted the multifix holder. But the topslide it self can be set to a degree, by loosing 2 bolts.. i dont think it will freely rotate a full turn if i remember correctly the topslide have the 2 bolts sitting in two circular slots.

Navigation

[0] Message Index

[#] Next page