Gallery, Projects and General > How do I??

How do i go about turning a crown on a idler wheel.

<< < (4/4)

NeoTech:
I actually found turning a Morse taper easier than turning this.. More or less cause the morse taper is of a smaller diameter and a longer stock. But yes, your right. Turning bevel and blend em with emery works.. i was looking for a easier way to do it i guess.

NeoTech:
I went about and tried to crown the wheel in question. i messed it up in 2 places

1) the crown is slightly more angled on one side.

2) when puttin bearings in the idler, i missed on the hole with the thickness of 2x 80g paper pieces.. and this heavy idler will vibrate so slightly.. i will fix this with a collet of paper and some cylindrical locking fluid.

Navigation

[0] Message Index

[*] Previous page