It went a bit wrong

it turns out the machine is capable of lifting way more weight than the base can handle which is going to force a rethink and modification. It was all fine when I was lifting buckets of dirt but then I lifted a big concrete cloths line post along with its big block of support material. slewed the machine around and the base frame started to buckle (pictured).
So to solve this little problem I am going to cut the base frame down a bit and get rid of the adjustable rear axle and have it fixed in place. as well as doing this I am going to weld plates along the sides and just sure everything up in general.
As a little side note I thought I would post a pic of the kind of thing I make for a living, dont usually take pictures at work but this frame is a little different to the basic A frames I make most of the time.