| Gallery, Projects and General > How do I?? |
| Digital Angle Gauge won't reset after battery change... |
| << < (2/7) > >> |
| z3t4:
--- Quote from: DavoDavo on June 05, 2012, 10:10:32 PM --- thus buggering it. :zap: --- End quote --- Indeed. Have you tried it in the freezer for a couple of hours/overnight? |
| David Jupp:
Mine looks identical - nothing in the (limited) instructions cover your problem. All I can think of is to try turning off & back on (see if that re-sets it). Alternatively you could try holding calibrate button for several seconds... |
| mklotz:
Sometimes on these devices a reset can be accomplished by removing the battery and then shorting the battery terminals inside the device. Give it a try. You have nothing to lose. |
| DavoDavo:
--- Quote from: David Jupp on June 06, 2012, 12:37:31 PM ---...All I can think of is to try turning off & back on (see if that re-sets it). Alternatively you could try holding calibrate button for several seconds... --- End quote --- Done all of that, many, many, many times. Tried pressing all combinations of buttons while powering up but I think it is supposed to go through some internal reset process :loco: before the buttons become active. Thanks for the reply though. |
| DavoDavo:
--- Quote from: mklotz on June 06, 2012, 12:54:06 PM ---Sometimes on these devices a reset can be accomplished by removing the battery and then shorting the battery terminals inside the device. Give it a try. You have nothing to lose. --- End quote --- I hoped that would be a simple solution, but... too good to be true, unfortunately. It didn't work. :bang: Thanks for the suggestion. |
| Navigation |
| Message Index |
| Next page |
| Previous page |