Catchy title eh?!
Just a "quick repair" Well, that's what My bruver figured anyway!
So somewhere in the region of 6hrs later (two separate sessions) I have two levers out of a lump of ali cast.
The rest is pic's

Find a usable lump....

And make this from that...

Then a little "rough and ready" marking out... Used the DRO to find the mark for the hole as well as scribed lines. The rest of these are pretty much free hand.

Cut the slot and then round off the edges.

A bit of hacking and whacking with a big slot drill and it's taking shape. (I'm not too concerned with the steps in the underside. It's as good as it needs to be)

One finished and one requiring some grip.

Finished...

And working...

Well, that's that.
Just another tick off the list. And bruver is happy.
This was a trade off for two high grade areospace ingots

Incidentally this lump of cast is Japanese cylinder head grade

Ralph.
Are the pic's a little big?
Think I might have altered my settings when I resized some other pic's?
If it's an issue I'll sort it.