Gallery, Projects and General > Project Logs

Kennet Tool and Cutter grinder

<< < (3/13) > >>

MadNick:
Morning!

Yes, you have quadrupled my normal inbox content this morning!

Much appreciated and prefect for finding out what is needed.

re The motor your notes said a 1/4hp 1440rpm motor would suffice instead of a 1/6 and this one came up so...

Ill have a little look for something a bit more, 'delicate' (like me).

N

Fergus OMore:
As you have a 'short wheel base' Kennet and mentioned getting it on the the smaller base, I sort of thought- 'ooh, err?'
Again, it isn't very protected from gr-gr- grit, is it?

OK,  change the pulley. Face East and - you know what to look for :clap:

You are getting there :beer:

MadNick:
Afternoon,

I made a quick start on the kennet. Thanks to Norman we were able to identify one of the table supports was missing.

I decided to have a crack at making one.

I hacked a chunk of this piece of old steel -



And spent the afternoon getting things square and clean -



Not much to report but its all progress :0

Nick

Fergus OMore:
Oh dear, you are behind schedule!  :hammer:

OK, one bit of plate as a base- bore a hole in  the pillar thingy and away we go- laughin' and scratchin'   :beer:


This way you have a tool and cutter grinder working

Cheers

N

I'm not just a pretty face-- as you will find out-- if ever we get to a Chinese nosh :clap:

MadNick:
Im on the case!

"I'm not just a pretty face-- as you will find out-- if ever we get to a Chinese nosh"

You know what, I may even REQUEST a trip to Newcastle for that pleasure!

Nick

Navigation

[0] Message Index

[#] Next page

[*] Previous page