Gallery, Projects and General > Project Logs

Kennet Tool and Cutter grinder

<< < (4/13) > >>

MadNick:
Morning!

I was busy last night, working on the missing table support. Thanks to Norman I was able to get an idea of the dimensions.

I turned my square block into -



To give you some idea -



Next I need to cut two slots into this piece, one to fix the pivot you see above, the other in which the pivot will slide.

Nick

Fergus OMore:
Most impressed on how you have got on with only a bit of sketchy report in an e-mail etc to go on.

I am looking forward to it when it is 'all singing, all dancing' and doing the  things which it is capable of doing. :beer:

DaveH:
Nick

Well done  :thumbup: :clap:

Looking good

 :beer:
DaveH

MadNick:
Afternoon,

Well so far so good. I milled the top slot out and then chain drilled the inner slot and cleaned it up with an end mill to produce -



Exude baby exude!



I tack welded the table support square to its base and balanced the whole thing together to give me encouragement to the project -



The table support base is located by way of pins and a clamp, I believe. These will be my next step.

Nick

Fergus OMore:
By now, Nick should(  :doh:) have the drawing of the locating peg.

I'm going to need a Sabbatical after this  :bow:

Cheers

Norman

Navigation

[0] Message Index

[#] Next page

[*] Previous page