Got this a few years ago, ( A FEW) finally getting around to fix en her up. It's the 14" model, 28-290.
Needed the Table stop pin, ran across Rog's I think his name is, did some reading, and made the stop my self. He also made the tapered pin for the table, but I was not up to trying that, (don't have a taper attachment, did not want to fool with offsetting the tail stock. Got one at ACE for a few dollars, BTW it is a # 6, fits well.
Got new "polly" tires, getting it all painted up, cleaned up,
Will post more pictures later,
Here is the table stop I made, and the clamps I made that hold that metal box/belt guard to the base.
The table stop sets on a 5/16X18 bolt coming up through the casting with a jam nut on it to lock it. The Idea is If I want to tilt the table to the left, I tilt it 1st. to the right, and pull the table stop off the bolt, then tilt to the left.
The places that sell delta parts want $90.00 some dollars for it!!!
The clamp with the round head screws shown, is the OEM delta one, and the two I made (only one shown) sport the hex headed bolts.
The places that sell delta parts want around $15.00 each for the clamps!!!