| Gallery, Projects and General > Project Logs |
| Set-Over Centre |
| << < (10/25) > >> |
| DaveH:
Wong, That is very nicely done, good use of the toolmakers clamps- clever idea. :thumbup: :clap: Milling is at the best of times a slow process, and you did a good job with your mill :clap: :clap: :clap: Looking good :thumbup: :thumbup: :thumbup: :beer: DaveH |
| wongster:
Hi Dave, Thanks. Really feel good everytime I read your comments despite knowing that I did screw up on some parts. Thanks for the encouragement! Regards, Wong |
| krv3000:
HI wong Very well done |
| Fergus OMore:
Question! How are you going to cope with the three dimensional effect of Pythagoras when all is said and done. Euclid only did it in two dimensions, if I recall :coffee: |
| Miner:
Norman, The dude that thought that up was bit behind times. If? I'm reading your referances correctly, A dial indicator across the top till it reads true will straighten out that theroy. Royal did much the same on their no longer built screw adjustable centers with a built in level. Pete |
| Navigation |
| Message Index |
| Next page |
| Previous page |