Gallery, Projects and General > Project Logs
Adding Digital Readouts to my Mill/Drill
<< < (5/5)
75Plus:
Darn it Chuck, now I have to remount my "Y" axis so I can use the same type guard that you used.   :palm: Your project is really looking good.  :thumbup: :thumbup:

Joe
cfellows:

--- Quote from: 75Plus on January 03, 2012, 05:24:59 PM ---Darn it Chuck, now I have to remount my "Y" axis so I can use the same type guard that you used.   :palm: Your project is really looking good.  :thumbup: :thumbup:

Joe

--- End quote ---

Sorry to cause you extra work, Joe!  I actually had a couple of near misses on this part.  If you look at the front on view of the Y-Axis mount, you'll notice that the assembly is screwed to the y-axis slide through a couple of slots at the top.  These started out as just holes and the first time I bolted it up, I discovered that the readout head wouldn't clear the x-axis lead screw.  Thought I was going to have to rebuild the back plate, but quickly thought of elongating the holes into slots and lower the whole assembly by about 1/2" inch.   And, now I have the added benefit that the vertical  position is adjustable!  By the way, that back plate is 3/16" aluminum plate that is about 14" long and 3" wide top to bottom.  I've been trying to build things with material on hand and I happened to have that piece.

Chuck
cfellows:
I've got the readouts temporarily mounted with magnets.  Thought I would try it here for a while.  This seems like the best place to put them, easily visible from the front and the right side of the mill.  Also, out of the way of everything.  If I like like it there, I'll figure out shielding and placement of the wire leads to the readouts. 








Anybody who has experience with DRO's see a problem this location of the readouts?

Chuck
Pete.:
Looks fine to me, so long as your table handwheel is on the right.
Navigation
Message Index
Previous page

Go to full version