Gallery, Projects and General > Project Logs
Adding Digital Readouts to my Mill/Drill
<< < (4/5) > >>
cfellows:
Thanks, all, for the suggestions.

Got the swarf guard done and installed today.  I was originally going to use aluminum angle, but didn't have anything the right size on hand.  So, I cut a length of L-shaped steel from a 2" square steel tubing, .060" wall. 

Before I drilled the mounting holes:



After I drilled the holes and mounted it to the talble:



Here's a view from underneath:



Chuck
cfellows:
Got a good start on the Y-Axis mount.  The bar will travel with the y-axis and the read head stay fixed.  Unfortunately, I'll have to disassemble the table again to drill and bore holes in the side of the Y-Axis slide.





Chuck

75Plus:
Chuck, Please check your PM box.

Joe
fixerup:
 I was first inspired by Joe,  X axis tee slot installation and now Chuck protective cover. Thanks for posting the pictures.  Thanks to both of you, I know exactly what I'll be doing next time I' ll go in the shop.

 :mmr:

Phil
cfellows:
Finished up mounting the Y-Axis today.  This first picture shows some brass drill bushings I made so I could drill pilot holes through the base of the mill/drill for mounting the read head bracket.  I used 1/4" brass tubing with 3/16" ID so I could drill 3/16" pilot holes at the correct position and angle.



Here's a couple of pictures of the DRO mounted (minus the guard)





And here is a picture down from the top with the guard (shield) in place.  The shield was made with the remains of the square steel tube used for the x-axis gaurd.



Chuck
Navigation
Message Index
Next page
Previous page

Go to full version