Gallery, Projects and General > Project Logs
Ball or Radius cutter
<< < (4/15) > >>
adamriley:
Nick, I have the original topslide. The nut has more backlash than I care to admit though...
The lathe, at present, is original other than the 3 phase motor I've fitted, and the QCTP I'll be fitting next week.
I cannot for the life of me though figure out the backgear system.
Unfortunately I'm missing a LOT of the changewheels, and no 4 jaw chuck.
I might have to try turning a backplate at some time in the near future, and picking up a chuck.
Have you done any mods to the lathe at all?

Adam.
MadNick:
Afternoon,

Ive spent the morning making lots of tinsel out of ali.

Ralph's arbor suggestion in use -



The turret fitted -



I am really pleased with the results - the mandrel really made it all work for me.

Re the countersunk bolt to supply tension between the base and the Turret - the one I have is clearly too short, looks like ill have to wait until after Christmas now but I will try your suggested method of making it fit. In the meantime I can start on the toolpost and swivel arm.

It would be great to get it working before I return to work when my freetime will be siginificantly reduced.

Adam, have PMed you about the Barker.

Merry Christmas everyone.

Nick
75Plus:
Nick, do not forget that you need to keep swarf out of the thrust bearing.

Joe
MadNick:
Thanks Joe,

Im working on a collar for that :)

Nice bike BTW - is that you?

Nick
75Plus:
  :offtopic:

 Yep, that's me. The bike was a 1952 Harley 45 cu. in. flathead. The picture was taken in 1956. A lot of water has passed under the bridge since then.

Joe
Navigation
Message Index
Next page
Previous page

Go to full version