| Gallery, Projects and General > How do I?? |
| Cap bolt question |
| << < (3/3) |
| John Rudd:
--- Quote from: AdeV on November 19, 2011, 02:37:10 PM ---Um, I suspect you're right John, I need a counterbore to hold the cap-head of the bolt... you get the picture... --- End quote --- In that case my previous post provides the dimensions....... :thumbup: Sorry for being so picky.... |
| AdeV:
John, your cap-head bolts measured exactly the same as mine: 16.12mm... Predictably, my 16mm milling cutter cut a dead accurate 16mm hole... so the heads wouldn't fit. Rather than adjust the main sump, I just turned a few thou off each cap head (as suggested by Andy) so it fitted nicely, job done! I should probably put some kind of rust-proofing on it, if I can be bothered... |
| Navigation |
| Message Index |
| Previous page |