HI just a up date I have bin on with other things and engine No13 has got left but I have bin on with it as with Meany things sum of the processes that i have dun IE the building of the Cross Head and the making of the 8 legs that it stands on I did not do any pics but i did tack sum of the making of the con rod and sum over all pics of things dun so far I cud have made the con rod out of 1 peace of brass but I decided to do sumthing different the man rod is of aluminum with brass ends I did not have any aluminum of the right diameter so i had to mashen a peace of 13mm DI dawn to a DI of 6mm the next bit no pics of but to a tach the little end the 6mm rod was center drilled 2.8mm then reamed to 3mm the little end I had all ready machend it up with a 3mm tale on the end by 12mm long this was with sum Bering fit and with the tale stock was preset in to place I then drilled a 1.5mm hole 8mm dawn from the top of the rod and I made a aluminum pin to go in then direst it off the cross slide end once a gane the rod was center drilled and tapt for a M3 by 12mm deep thread the cross slide was drilled on center 3.1mm then canter sunk for the screw right pics