cheers Lads
Ade ,,,,,,,,,nope stainless
Well thought all i had to do this morning was poke a few holes in the Knee to fix all the parts i have made , Z and Y bearing blocks not a problem then came the Z motor mount
this face was not square nor flat
.
**** no's what they used to machine this face
, So i ended up having to re machine this face .
wile on i cleaned up the jolly hockey stick hole too.
Must admit the machining and build quality of my Chester 626 mill is utter crap
, on a side note , any one with one of these machines dont even think about ordering spares ,as i will lay odds they will not fit your machine .
With that done i could now fit the Z motor mount .
Must order a box of shorter M8 socket cap screws .
Rob