Gallery, Projects and General > Gallery

Dual Purpose Lathe Carriage Stop

<< < (2/2)

Henning:

--- Quote from: Lew_Merrick_PE on September 07, 2011, 11:11:44 AM ---
--- Quote from: Henning on September 07, 2011, 06:24:10 AM ---Is the dial indicator only held on by the magnet?
--- End quote ---

No, if you look, it is held on by the screw/extended-nut clamp that locks the extending bar.  And yes, it is nicely done!

--- End quote ---

Thanks, noticed now you said it.

AndyB:
That is marvellous! :bow:

I saw a saddle stop mounted on the side of the bed casting in ME magazine but my Drummond is round and wavy at that point so could not see how to mount one. :doh:

Yours is absolutely what I need and so many other uses too :clap:

Many thanks

Andy

Navigation

[0] Message Index

[*] Previous page