Gallery, Projects and General > Gallery

Dual Purpose Lathe Carriage Stop

(1/2) > >>

Aestus57:
Hi again folks,

Got the bug at the moment and can't keep out of the workshop!!  Put together this Lathe carriage stop for my Warco 918.  The "dual purpose" bit means I can attach a Dial gauge at the same time, or use without, whatever, anyway I'll let the photos tell the story.

 :mmr:

dickda1:
Nicely done! :thumbup:
-Dick

DaveH:
Very neat, and useful also  :thumbup: :clap:
 :beer:
DaveH

Henning:
Nicely done!

Is the dial indicator only held on by the magnet?

Lew_Merrick_PE:

--- Quote from: Henning on September 07, 2011, 06:24:10 AM ---Is the dial indicator only held on by the magnet?
--- End quote ---

No, if you look, it is held on by the screw/extended-nut clamp that locks the extending bar.  And yes, it is nicely done!

Navigation

[0] Message Index

[#] Next page