I was looking around for a way to make up a cutting guide, for the plasma. When it hit me I could screw a couple of super magnets from hard drives that I saved when I was scrapping computers for the mortgage companies that went under.

Since I was just cutting out the good section of box tube from scarp I first tried using ½" ply wood and short wood screws. Next time I will use ¾" plywood and put through bolts and nuts as after 5 or 6 times of moving the board the screws pulled out of the board.

on the piece

Cut only thing is it doesn't work good with the thin ply on the curved end I think the thicker material will help some.
Plus the added time saver/hassle of not messing with clamps! Posted Image