Pressure fitting 1/32" wire to make a pin wheel.

Gallery, Projects and General > How do I??

<< < (3/8) > >>

DaveH:
Chris,

I have cut 1/16" stainless on my sherline. Basically it's a deep score, then I bend it to and fro until it breaks.
I clean the ends on a small grinding wheel (Dremell).

But a 1/16'' is not 1/32nd. whether it would work with 1/32nd I have my doubts.

I would just cut them and clean the ends up.

Well thats my 2p's worth.

DaveH

HS93:
these are the diamond wheels i posted about , I have cut 1/8 silver steel and 4mm and 5mm stainles steel with then nice very clean cut and the shaft stays stright.

http://www.axminster.co.uk/proxxon-shopproxxon_pg1/#page=12

Peter

raynerd:
Pete, thanks for the link but I hit a search page... I can`t see a 25mm one. I can only see two diamond disks, one has cooling holes in and the other is solid and available in 20mm dia or 38mm.

raynerd:
Pekka, I really appreciate your time taken and the photos posted but I know my limits and I really think that I`d bend the rod. I have struggle parting in general and I think something so small I`d really struggle with, besides, I`ve no cutting tool that would be suitable - I expect a dremel like Pete is saying is likely to be my first port of call.

raynerd:
Pete, this the one:

http://cgi.ebay.co.uk/Proxxon-Diamond-Cutting-Disc-20mm-/300522248853?pt=UK_BOI_Building_Materials_Supplies_Carpentry_Woodwork_ET&hash=item45f8859a95

Navigation

 Message Index

Go to full version