OK, here's an update.
Finished modifying the steering rack. Instead of tacking a bush on one end, I decided to machine a press fit bushing on the lathe to press into the rack. I might have to bore it out a bit more, but at the moment it works perfectly.

Rear bearing plates arrived from Edge, so now the rear swingarm is 100% complete except paint

520 50 tooth sprocket from a motorcycle shop in Brookvale was $40 new. The guy went through all the 520 50 tooth sprockets to find me the cheapest, AND then he gave me a discount! I think it looks pretty good. The place was called APW motorcycles.

Picked up a seat on ebay. A friend and I bought the pair for $140, and I got the more faded one because I need the reclining lever on the left. It won't fit on the right because of the engine.

Mounted the oil cooler at the back of the buggy. If I was to do it again I would save some money by using rigid steel pipes, rather than the expensive oil cooler pipes.


Removed the rear brake assembly from the bike

Made the suspension pivot pins. The rear one is a bit longer than stock because I made the pivot wider.
Instead of threading the end of the pins I decided to use cotter/split pins through the end of the bars. I also bored out the nuts to weld them on the pins, rather than threading them on.

Seat rails without the holes drilled in them

One of the wing supports done. It was easier to cut the correct angles than I expected

Also, I fitted the front suspension mounts. I had to tack and grind off the top suspension mount like 10 times to get it in the right spot and square to everything. Magnets helped hold it in place but made the arc (during welding) go a little bit strange

I hope to have the buggy done by the 1st of feb. It will be close, but I think I can make it, especially if my friend comes over to help.
Andrew