| Gallery, Projects and General > How do I?? |
| Mini Lathe Electrikery....... |
| << < (13/19) > >> |
| John Swift:
Hi Dave D and Dave BC , just incase you didn't look at all of the cnczone link I've added the circuit I traced for of the small pcb with the blue relay hope the tests go well tomorrow John |
| Stilldrillin:
John. Thank you! I did have a look..... Then me brain started overloading again........ ::) The motor and board are on their way from Amadeal. I will take advice before installing em. I can repair the blown copper trace with a soldered wire. I'm meeting Dave BC at a local show, next weekend. He can have the board to play with then....... :thumbup: At the moment, I'm hopeful I can cope with a simple unplug/ replug....... Mebbe! :palm: David D |
| lordedmond:
David just swap the wires one at a time and you will be fine Stuart John Swift on the first pic shown by David all I see is three cap's a R and an inductor the big yell thing is marked c3 with the blue ones c1 ,c2 I do not see any relays on that particular board Stuart |
| Stilldrillin:
--- Quote from: lordedmond on May 20, 2011, 02:49:18 AM --- John Swift on the first pic shown by David all I see is three cap's a R and an inductor the big yell thing is marked c3 with the blue ones c1 ,c2 I do not see any relays on that particular board Stuart --- End quote --- Ohhh....... Stuart!! Pleese........ Don't start all that, all over again! David D........ |
| John Swift:
Hi Dave , add a lable/ marker to one of the red wires that connect to the control pcb then take a photo or make a note changing the wires over one by one is a very good idea but you need to have a plan B if some wires come off by accident ( been their :lol: ) PS just spotted the cable ties your photo on page 3 gives all the detail you need PPS using your photo just added your wire colours to a diagram of the control not sure of order of mains wires but ties help to get them right Hi Stuart , the relay board is in the control box with the speed control PCB the relay circuit could be use full while fault finding since it is an interlock for the power and switches the 27 ohm braking resistor the damaged filter PCB is in a plastic box hidden by the motor cover at the rear of the machine John |
| Navigation |
| Message Index |
| Next page |
| Previous page |