« previous next »
Pages: [1]   Go Down

Author Topic: Strange CNC problem...  (Read 4880 times)

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5534
  • Country: us
Strange CNC problem...
« on: April 26, 2011, 06:41:50 PM »
So I am half way through CNCing my mill. I originally had an el cheapo Chinese TB6560 running my steppers. Ran errr so so. I ended up replacing them with KelingCNC C10 BOB and some CW250 Drivers. The Y axis runs flawlessly. The X axis... not so much. Seems like it is a gamble on whether the stepper will run + or - along the axis. Hit the X+ (Mach 3) to jog it, and it may or may not go in the correct direction.

Any ideas?

Thanks
Eric
Logged
Science is fun.

We're all mad here. I'm mad. You're mad.

Offline John Stevenson

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1643
  • Nottingham, England.
Re: Strange CNC problem...
« Reply #1 on: April 26, 2011, 06:47:25 PM »
Sounds like a fault on the direction to that driver.

First off swap drivers and see if the fault moves axis.

Just had a thought , you are not using pin 1 on the BOB are you ?
Pin 1 isn't a high speed port.
Logged
John Stevenson

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5534
  • Country: us
Re: Strange CNC problem...
« Reply #2 on: April 26, 2011, 07:08:20 PM »
Nope on the pin 1.

Going to swap the drivers and see if it moves. Is this a common type of error?


Logged
Science is fun.

We're all mad here. I'm mad. You're mad.

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5534
  • Country: us
Re: Strange CNC problem...
« Reply #3 on: April 26, 2011, 07:34:18 PM »
Not sure what it was... but it is fixed. I tore it down to swap the drivers, put it back together and lo and behold... it works.  A bad connection I believe.

Thanks for the help guys!   :beer: :beer:

Eric
Logged
Science is fun.

We're all mad here. I'm mad. You're mad.
Pages: [1]   Go Up
« previous next »