| Gallery, Projects and General > Project Logs |
| Hit n Miss Engine ,,,,to MR D Kerzel's design |
| << < (12/38) > >> |
| lordedmond:
Kenneth It a wobbler ( sprung loaded center ) held by the TS and the dial gauge is used to check the run out ) Basically its a centre finding device to set thing running true But I bet Rob can explain it better |
| Rob.Wilson:
Hi Ken I can see how the photo is misleading :doh: ,,,,,,,,,,,,,, i had done a video to show it in operation to :( ,,,5 minutes until upload complete . Rob |
| Rob.Wilson:
--- Quote from: craynerd on April 28, 2011, 08:22:47 PM --- Just curious, what determines whether you choose to use your horizontal setup or a standard vertical? - I know there is always more than one way "to skin a cat", but just curious how you personally decide. Chris --- End quote --- Hi Chris ,,,,,,,,,,,, i mainly just use the HZ for profile cutters , gear cutting and deep slots :dremel: :) Rob |
| Rob.Wilson:
I am just as crap with video as i am with photos ::) ,,,,, but you get the idea :dremel: Rob |
| saw:
This was wery intressting thanks for showing Rob. |
| Navigation |
| Message Index |
| Next page |
| Previous page |