Gallery, Projects and General > Gallery
BIG Thanks To Bogs aka John Moore!
bry1975:
I rebrush and clean up bezels with the trick below as it's often very difficult to hold certain parts in a 3 or 4 jaw chuck.
Facing plate with industrial strength double sided tape!
Bry
P.S. takes a good twist of the screwdriver to lever the caseback off the facing plate!
Brass_Machine:
Nice job John!
Bry, the watch looks great now.
Eric
bry1975:
Thanks Eric!
HS93:
I use this methoud to hold bits down but use IPA Isopropyl Alcohol a quick squirt leave for a few min and it falls off anddoes not normally rust the surface (well not my mill anyway) and dries very quick and you are left with no resedue.cleans things well as well great for around the shop (and house).
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=390274566925&ssPageName=ADME:B:EOIBSA:GB:1123
Peter
bry1975:
Thanks for the recommendation Peter I'll have to try some oh and the facing plate
is ally. FYI I run the 3 jaw and 4 jaw and facing plates on my father's Myford ML8 wood
lathe works a treat for brush finishing and polishing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version