Gallery, Projects and General > Gallery

BIG Thanks To Bogs aka John Moore!

(1/4) > >>

bry1975:
Thanks for machining the replacement Tag Heuer Bezel John the watch now looks decent. :thumbup:






Old knackered bezel:-

Bogstandard:
No problems Bry. I'm glad you are happy with it.

That case looks a lot better than the last time I saw it. Had it been run over by a car? It certainly looked like it.


John

raynerd:
John, how did you go about maching that part, did you take an pictures? I`m thinking more about how you held it.
Cheers
Chris

j45on:
Nice job  :thumbup: the old one certainly was a mess.

Bogstandard:
Chris,

As this was a private request, I don't normally take pics of the processes, just the finished article.

But a quickie explanation.

The internal dimensions and boring to fit the crystal OD was all done on the original stainless bar held in the chuck. It was then parted off and turned around. It was then held with an expanding 5C mandrel turned to size to fit the inside dimensions of the bezel. I was then able to put the two outside tapers on.

I hope that helps

John

Navigation

[0] Message Index

[#] Next page