Gallery, Projects and General > Project Logs
Valve Base
Darren:
This is what would have been used, though this one is much smaller it's the same design
Apart from the fact they are no longer avail, and I've yet to see any pop up on Ebay in the last 3yrs, you could say they are a bit difficult to find.
rleete:
Looks like I just reinvented the wheel, then. I'm assuming the outer profile of the insulator doesn't matter, just whatever appeals to you. You ought to be able to machine that up, and so the looks of the connector part aren't so important, just the function.
bogstandard:
Darren,
Might be a stupid idea, but could you use terry clips.
C-o-C attached
The heat resistant insulation might be the problem.
John
HS93:
How about a Plug cap (mini spark plug) cut down if need be and the internals of one of the ceramic caps.
peter
Darren:
Thanks Guys I'm working on something this evening, not ready to show just yet though.
John,
I've seen those clips on the market stall and did give them some consideration.
I have to think about safety foremost but almost as important is the finished looks.
Apart from that I'd like to make something myself, after all, it what we have these tools for init :thumbup:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version