Many thanks for the replies guys, I never know if I am doing things correctly by using these storage sites.
As long as you can get them, that is now fine with me.
If anyone is interested, I do have four more from the same series.
Turning two diameters, shows the use of both right and left hand turning tools.
How to run a lathe, based around an old South Bend, but anyone with an old type of lathe like this would benefit from it, especially a beginner to machining.
Turning a large acme thread.
Cutting a taper using both the compound and a taper turning attachment. Get to know how to use correctly, that bit gathering dust at the back of your machine.
All vids are around 14 mins long and contain very good rock solid techniques that could easily be used on modern lathes.
Bogs