« previous next »
Pages: [1]   Go Down

Author Topic: Kenett Cutter Grinder  (Read 11649 times)

Offline Mike Cole

  • Jr. Member
  • **
  • Posts: 45
  • Country: 00
  • Wallasey Wirral
Kenett Cutter Grinder
« on: December 28, 2010, 09:53:07 AM »
I have been making this Kenett Cutter Grinder on and off for the last 3/4 years. Although still not fully finished it is quite usable so just decided to give it a lick of paint.
I have also posted a view of sharping a old carbon steel tool i use for very fine cuts. Hope you can see the razor sharp edge.

Mike
Logged

Offline John Stevenson

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1643
  • Nottingham, England.
Re: Kenett Cutter Grinder
« Reply #1 on: December 28, 2010, 10:19:21 AM »
Can't see anything, pictures are far too big and blurred
Logged
John Stevenson

Rob.Wilson

  • Guest
Re: Kenett Cutter Grinder
« Reply #2 on: December 28, 2010, 11:00:37 AM »
 :scratch: you got the right pair of glasses on John  :poke: :lol: Photo look fine to me  :D

Looks a good bit of kit you have made there Mike  :clap: :clap: :clap:  handy to have in the shop ,,,,,,,,,,, one day i may get round to it  :coffee:


Rob

Logged

Offline Mike Cole

  • Jr. Member
  • **
  • Posts: 45
  • Country: 00
  • Wallasey Wirral
Re: Kenett Cutter Grinder
« Reply #3 on: December 28, 2010, 11:59:24 AM »
The photos are n't the best, I will try and take some better ones.
 I think they are too large too. What is the best size to post?

Just been out working on the lathe. took some test cuts and put messed around with mounting feet . rejuced  taper error to a gnat cock above zero. very pleased :ddb:

Mike
Logged

Offline John Stevenson

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1643
  • Nottingham, England.
Re: Kenett Cutter Grinder
« Reply #4 on: December 28, 2010, 12:35:20 PM »
Mike,
If you aim for 800 pixels wide it fits most screens without having to scroll.
Logged
John Stevenson
Pages: [1]   Go Up
« previous next »