Hi all this is my first try at posting a picture, so please bear with me if I have to have a couple of goes.
These are a couple of easy builds suitable for Christmas presents /socking filling for wife/mistress. The first one is a necklace holder. Just use what bits you have in workshop. Consists of brass base with post around 10 inches high. Three horizontal 'sticks' of slightly thinner diameter at top. I used Hex bar as this is what I had. Silver solder togetter and polish.
The second one is a cotton wool pad holder. I had a length of ali tube just the right dia for the cotton pads that my wife uses( makeup removal). Again something around 10 inchs high. Put a wide slot all the way down one side about 0.5 wide. I then parted off a slice of ali bar around 3 inches dia to provide a base. I mounted on the rotary table to mill a grove for the tube to sit in. Hot glue to fix tube to base. Clean and polish.
Mike