Gallery, Projects and General > Project Logs
stuart 10v build
scrapman:
Thank you for the comment Nick.
Ray.
scrapman:
Well i have done a bit more on the engine today,
Drilling the crankshaft bearings,
Turning the bearing,
drilling the bearing
checking the bearings for fit,
bearing fitted and tapped 1/8 x 40 for the oilers,
all comments and advice would be appreciated, Ray.
Stilldrillin:
Looking good, and taking shape nicely Ray! :clap: :thumbup:
David D
raynerd:
Ray.... friend..... slow down... this is not a race!! :lol: :lol: :lol:
Well done Ray, you had the lovely situation of being provided with one piece for the bearings. I had two little pieces so drilling them aligned was hard work. Once the cylinder and covers are done you`ll be where I`m up to. :doh:
...anyway... no time to type! :dremel:
scrapman:
Made a start on the crank this evening,
Chris, Congratulations on passing the foundation course,
Thank you all for the comments , 73'S Ray MW0COE
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version