madjack you could always get your inkjet print photocopied then you could iron it or there is a good video on etching a board using the photoresist method here
I always assumed you had to use a UV light to do this which is why I went with toner transfer but I think I will give this a go next time
http://madmodder.net/index.php?topic=2849.0Guys I have some questions about my stepper motor I have to freely admit I know jack about them
The one I have bought has eight wires and the driver has 4 outputs and is labelled as a "bi-polar driver"
So as far as I can tell from the instructions I have two options series and parallel

Also I noticed at the bottom of picture 2 that
Arc Euro motors supplied with their rotary tables are wired in parallel so am I correct in guessing thats what I should do ?
The final picture labels the wires from the stepper driver as A+ and A- / B+ and B- yet no mention is made of wire polarity on the motor data sheet
Now I'm super confused




