Gallery, Projects and General > How do I??
x2 tramming
krymis:
so i got a little more on the tramming tools done. I used some steel angle to make the column tilt mod. I got the x axis dialed in less than 0.0005. I am putting y axis adjuster screws in the same way sonny harrison did. I should have that done today.
krymis:
so i figured out that i had to much slope in my holder holding the DTI to the spindle. So the key was to break out a Starrett DI set up and the x axis is now within .001. I am now working on the y axis again. then all should be good and i can make all the little widgets to make tramming a lot easier. I finally feel like i am getting some where with this machine. I have had 4 of these and have never had this much trouble and questioned my methods like this. I now have the 8x6x.5" steel plate on the haas minmill to make the backplate.
Bogstandard:
Once you have your mill up and running again, maybe you could consider making a tramming tool.
http://madmodder.net/index.php?topic=822.0
Bogs
Brass_Machine:
--- Quote from: bogstandard on November 04, 2010, 04:24:06 AM ---Once you have your mill up and running again, maybe you could consider making a tramming tool.
http://madmodder.net/index.php?topic=822.0
Bogs
--- End quote ---
Bogs is right...
Once my mill is back in tram, I am going to make one.
Eric
krymis:
sorry for the not posting up guys...my father in law passed this past weekend so i have been taking care of some of the estate things and such. So today i am hoping to get the tram all finished up and make some parts.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version