Gallery, Projects and General > How do I??
x2 tramming
krymis:
I have my x2 all torn down and ready to do what is needed to make it a good operating machine. Where should i start with putting it back together? I have a craftsman roll around tool box from sears to mount it on. I welded allthread and long nuts to the 4 corners of the tool cart to level it anywhere in the shop. I have the base laid on the cart for mounting but wondered if a filling with epoxy and sand mix would help it? any help will be appreciated.
spuddevans:
Hi there Krymis, I have my own X2 broken down in pieces as well, and have just done the 1st stage of tramming. I made brief reference to it in my post about my CNC X2 conversion. I've just gone out and taken a few pics and will upload them and make up a post about what I did and then I'll re-post here with the link.
Just give me a few mins to gather my scattered thoughts,
Tim
spuddevans:
Just posted it Here
Tim
krymis:
i am going to start tramming the head to the column tonight. I am planning to remove the controls and electronics box away from the mill. I will also be removing the motor and Z axis ballscrew and cnc mount. I will see how good i can get that before i move on to any other tramming.
krymis:
so i decided to take the tram a little further and add a treadmill motor and controller to the mill. I will also be using the hoss belt drive. I harvested the motor, choke, control board, circuit breaker, and POT from my wife's treadmill.
The parts are common place if you type in the right stuff on steal-bay..
motor is a B4CPM-089T (2hp 130v 5950 17A)
choke is a YBI-601-Q
it uses a 10k POT
and motor controller is a MC-60
all parts priced on steal-bay was under 100.00
i have videos of the motor testing and such from my cell phone. sorry for the crappy video. Also have a 1/2"x12" rod in the spindle and starting the tram process on the spindle. Once i get it in tram i am going to make a few brackets to help fine tram the x axis...y axis is just using some expensive shims aka tin foil. :lol:
pic of the control layout
Navigation
[0] Message Index
[#] Next page
Go to full version