Gallery, Projects and General > How to's

How to make a internal/external threading tool on your lathe

<< < (7/8) > >>

andyf:
Well, I can see the link, and have just tried it.

Below Paul's signature, and above the "Last Edit" line, it says:

 BD-LatheTools.pdf (100.96 kB - downloaded 204 times.)
 
I don't think that copy will work as a link. If not, you will have to go back to the first post and try to spot it.

Andy

mzt:
Ah!! Got it!
The link to the PDF won't appear unless You've logged in to the forum.

Marcello

RotarySMP:
Thanks for posting this. Sure looks easier than the internal threading tool I ground out of a normal 8mm HSS-Co Blank.
It would be easy enough to file a tip radius while it is still in the lathe, to ensure the correct root radius for a specific thread if desired.

For the external thread, you could have used the insert tool and jumped from


to this ...

Bishop:
Thanks Paul, I finally got around to making one of these tools. I can see making a few more sizes very soon, cheers.



Shawn

Meldonmech:
     
           Well presented pictures and wright up.

                                                                      Cheers David

Navigation

[0] Message Index

[#] Next page

[*] Previous page