Gallery, Projects and General > The Design Shop
oh no another ball turner
Rob.Wilson:
Looks like you had a good shift in the shop Jason :thumbup: :clap: :clap: :clap: :dremel:
You decided what insert you will be using ?
I must have a go at making a ball turning attachment :proj:
Rob
j45on:
"You decided what insert you will be using ?"
No not yet :scratch:
A TCMT looks the easiest to fit
but I also like the double ended VBMT that Ralph used but I cant figure out if I have room I may have made the tool post a bit small it is 1/2" square
No1_sonuk:
Mine's no more than 1/2" square at the top, and I use these:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=380251788233&ssPageName=STRK:MEWAX:IT
j45on:
--- Quote from: No1_sonuk on September 12, 2010, 05:46:55 PM ---Mine's no more than 1/2" square at the top, and I use these:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=380251788233&ssPageName=STRK:MEWAX:IT
--- End quote ---
:thumbup: just ordered some thanks
Divided he ad:
Hi Jason,
Looking good there :thumbup:
The VBMT16 inserts I used are fitted into a 1/2" (well actually 12mm) upright. No bother though, the 11's are the ones I fitted in the mini turner and they cut very well too.
Nice of that site to give you all the info on the tips, I had to measure everything and work it all out for myself :smart:
I can't remember accurately but I think I showed photo's of the process I used to fit the tips in giving the best support against sideways forces I could, I'm sure I posted a link somewhere on here :scratch: It's been a while since I was here ::)
Not long now and we should see your .... Erm, well, spheres :dremel: :lol:
Ralph.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version