Gallery, Projects and General > The Design Shop
oh no another ball turner
No1_sonuk:
--- Quote from: ksor on August 24, 2010, 05:32:11 AM ---Oh, yes - I'm making one too !
but I have NOT yet decided what kind of bit to use.
I wonder why most of you use this "arrowhead"-like bit - why not a round one - normaly a round bit gives a better finish.
Correct me (so I can choose the right one for my ball turner) !
--- End quote ---
The pointed one will get further into the "corner" by the shaft, making a smaller fillet between the ball and the shaft.
There's nothing stopping you using both. If you need the tight fillet, use a point, but if you don't, use a round one. You just need to make an extra tool holder.
j45on:
Slowly getting there :hammer:
Lapped together with valve grinding paste
A little drop of oil and it is a pain to get apart again:D
keychain torch + magnet = boring light :dremel:
Rob.Wilson:
Nice project Jason :thumbup:
Hows coming along ?
Rob
j45on:
Hi Rob
I have the material for the tool post now so hopefully I can make some progress this weekend :hammer:
I still have not decided which type or size of insert I'm going to use yet :scratch:
j45on:
I'm nearly done just need to shorten the cap screws and make a handle.
Right off to ebay to search for inserts :hammer:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version