« previous next »
Pages: [1]   Go Down

Author Topic: stadgren, perris jason pixi lathe  (Read 4222 times)

Offline ageofaquarius21

  • Newbie
  • *
  • Posts: 3
stadgren, perris jason pixi lathe
« on: July 12, 2010, 03:49:51 PM »
Greetings, anyone have information on the back gearing arrangement for the above mini-lathe? My thanks, Quincy Collins, Nova Scotia, Canada
Logged

Offline andyf

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1795
  • Country: gb
    • The Warco WM180 Lathe - Modifications
Re: stadgren, perris jason pixi lathe
« Reply #1 on: July 12, 2010, 05:03:37 PM »
Hi Quincy,

I've got a Perris like this:
http://www.lathes.co.uk/perris/ . Would details of its back gearing assist?
I think the present-day Cowells (they took over the lathe after Mr Perris died) 90ME has very similar arrangements.

Andy
Logged
Sale, Cheshire
I've cut the end off it twice, but it's still too short

Offline ageofaquarius21

  • Newbie
  • *
  • Posts: 3
Re: stadgren, perris jason pixi lathe
« Reply #2 on: July 13, 2010, 06:17:29 AM »
H, any end shot showing the gears and their bearings, etc. would be of interest! thanks, Quincy
Logged

Offline andyf

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1795
  • Country: gb
    • The Warco WM180 Lathe - Modifications
Re: stadgren, perris jason pixi lathe
« Reply #3 on: July 13, 2010, 07:26:42 AM »
Hi Quincy,

I'll send you a PM with some photos. I also have the original construction notes for my Perris SL90, and I put a PDF of them in the Files section of the Cowells 90 Group:
http://groups.yahoo.com/group/cowells_90/
The back gears are dealt with on pages 20/21/22 of the PDF (not the numbers appearing at the bottom of the scanned pages). You need to join the group before you can get into its Files section.

Andy
Logged
Sale, Cheshire
I've cut the end off it twice, but it's still too short
Pages: [1]   Go Up
« previous next »