Thanks for the mention Bob!
Haven't been to your blog in awhile... spent some good time there today.
Well stop swanning round the country drinking tea with three sugars in and get your finger out.
Bahaha

Don't worry Rob... I gotta work on mine too!
Eric
Hi Eric ,,,,,,, my mill works ,,,,,,,,,,,just i cant work it

will have a cup of tea and think about it
Anyone wanting a cool bit of software should take a look at Bob's GWizard ,,,,,,,,,,,,, downloaded it yesterday and used it today to get the position of the timing gear shaft on the casting ,,,,,,, a must for any shop

Thanks Bob
Rob