Here we go...the reversal control:
Milling the bearing blocks from hot rolled mild steel:
Milling the contour and roughing the holes:
Aligning both bearing blocks on the conventional milling machine to bore them out:
Boring job...
Drilling and boring a piece of flat, cold rolled steel for the levers:
They will be cut in single pieces after that
Back on the cnc machine, the jig to hold the levers:
Alignment happens by the big bushing and the small 3mm pin, the part is held by the M5 screw
Finished lever:
The bearing blocks with the levers and bushings:
Stefan