Well....... Hands up, all those who just
knew it wouldn`t be long before I was fiddling with it!
Listening to my vid, you can hear it
ticking.....
After some 4hrs+ of running, the tick had become a
tap.
Not wanting the tap to become a
clonk...... I have bushed the little end bearing to "nil" clearance, rather than the manufacturer`s 1/4mm.
The offset one, on the left.....
I set it up, and ran it in for an hour or so, on my rather cluttered workbench......
I think the job`s a good `un!
Sometimes...... Even I`m surprised!
David D