Gallery, Projects and General > Gallery
Extra quick change tool holders for my A2Z QCTP
swhite:
Dean,
I guess what your saying is 3 halfs make a whole... :lol:
wongster:
Hi Steve,
Are you able to share with me the dimension of the dovetail end? My measurements seem inconsistent each time.
Regards,
Wong
swhite:
Hi Wong,
I used a 60 degree dove tail, the slot is 21mm wide, 4.84mm deep and the dove tail is 25.65mm from edge to edge when it is cut into the aluminum. I hope this helps you.
Steve
wongster:
Thanks Steve. These are my measurements using the caliper:
Height: 5.22mm
Width of dovetail: 26.64mm
The slot: 21.06mm
What size dovetail cutter would you recommend? I've a 60 degree 1" wide. Seem a little big for this I think.
Regards,
Wong
--- Quote from: swhite on June 27, 2010, 12:14:17 AM ---Hi Wong,
I used a 60 degree dove tail, the slot is 21mm wide, 4.84mm deep and the dove tail is 25.65mm from edge to edge when it is cut into the aluminum. I hope this helps you.
Steve
--- End quote ---
swhite:
The dovetail cutter is a 3/4" 60
What material are you making your tool holders out of?
Steve
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version