Gallery, Projects and General > Gallery

Extra quick change tool holders for my A2Z QCTP

<< < (3/7) > >>

wongster:
I'm thinking of aluminum.  Any suggestion?  I've not tried working steel on my Sherline mill so far.

Regards,
Wong

swhite:
The tool post that I have came with aluminum tool holders so I made mine out of the aluminum also. I am sure that if you wanted to make them out of steel your mill would work fine, aluminum cuts so fast that I like using it on my Taig equipment. Do you have any pictures of projects that you have made?

Steve

wongster:
Mine is aluminum too, from A2ZCNC.

The only "project" I've done was the die holder, after some help from the folks in this forum, and the 1/2 done brass torch.  Pics attached.

Regards,
Wong

swhite:
Looks good!
Let me now how your tool holder comes out..

Steve

wongster:
Not too bad.  The cap of the torch was cut using the die holder.  Rather happy with the result.  There again, I've nothing I can compare with to know if it is the way it supposed to work.  Pretty new to machining.

Regards,
Wong

Navigation

[0] Message Index

[#] Next page

[*] Previous page