I bought a 13x40 Enco last year with around 88 threading gears but, without a thread chasing dial.
I've made a fairly decent setup, but, not sure where to drill the hole to mount it on the carraige.
Which is very surprising as I believe it came from a gunsmith as the tailstock was set over for a taper cut.
There's no sign of one being installed, Enco is not any help, though I did buy a screw following gear
that actually fits.
I'm not able to post pictures at this time as the HP do it all keeps insisting: press enter to align cart,
500 times. Once that would kick in, then I could post 'em. Actually I could use some help there too!
Many thanks for any help here.
George