Thanks for the welcome!!
I've got a C3 lathe...7"x 14" about five years old and an X2 mill, which is about 18 months old.
No wireless here, I flew free flight for about 30 years, mainly F1B (Wakefield) but also some F1A, Open Rubber, a little bit of Open Power and Chuckie (HLG). For the last 3 or 4 years I've been trying to remember what I have forgotten about control line since the '60's. Started off flying Vintage Combat, but now realise that I'm too old and too slow, so am now looking at alternatives, like stunt.
The engines that I'm interested in are mainly small capacity diesels, in fact there are three (!!!...should get one that works!) ML Midges on the way, they are 0.8cc side port diesels, similar layout to Mills 0.75 of fond memory to some people. The next project is a Sugden Special from the Aeromodeller in the mid '50's.
The photos may be a problem, but I'll post what I can. I was inspired to join this group by bogstandards thread about Darrens lathe.
cheers
Bill Pudney
Adelaide, Australia