| Gallery, Projects and General > How do I?? |
| Rings? Sorted!! |
| (1/3) > >> |
| BK:
I need to cut 8 rings 3 - 3/4" OD from 1.25mm black plate, the internal is OK I have a 3" hole saw (my biggest). I should be able to hold the plate in the lathe before I cut the centre out, but I'm unsure of the best way to do this. :bang: |
| sbwhart:
Hi BK First thing is don't drill the hole first if you have you've made thing difficult for your self. Starting again the way to do it is to friction turn the OD:- roughly cut the OD into a circle with a saw or by what ever:- Put a big centre roughly in the middle, put a dollop of masking tape on the back of the blank, then with a stub of material held flush to the jaws of the chuck trap the work with a running centre up against the jaws, with you lathe in the slowest speed you have nibble the disc into a circle, when this is done drill the hole in the midle. A bit like this Hope this helps Stew |
| John Hill:
You need a trepanning tool, which not hard to grind, for the lathe but you also have to arrange a holding system so that your ring can not fall free when it is cut out. If it falls free it will likely be looped around your cutting tool and will get jammed by bits of the whirling chuck or attachments on your face plate producing a nice metal pretzel and in my case a barely avoided laundry emergency. What I did when making gimbal rings for my gyroscope was make a wooden disc to mount on the face plate. I drilled a hole near each corner of each piece of steel (square of 1/4" mild steel) and mounted each piece to the faceplate by bolting the square to the wooden disc. Then I used the lathe to drill a hole in each plate and passed a threaded rod through the spindle to lock the centre of the plate to the face plate. Then I made the first cut using my trepanning tool, I cut the inner cut first but I think you could do either. That cut left me with two pieces on the face plate, the inner round bit and the outer square piece with a big hole in it. There was a gap between the two pieces left by the width of the trepanning tool and I put a number of wood screws in this gap then when I made the next cut the wood screws held the cut off ring to the face plate. There is probably an easier way to do it but that is what I did after having a tangle with my first attempt. John |
| BK:
OK John, who and what is a trepanning tool?? or is it a Kiwi term for something I already know about??? :wave: The inner circle I'm not worried about, the outer is the pain. Stew, some food for thought in your reply, thanks. |
| zeroaxe:
For a lathe, this is a trepanning tool: And for a drill/mill, this is your ticket: |
| Navigation |
| Message Index |
| Next page |