| Gallery, Projects and General > How do I?? |
| Rings? Sorted!! |
| << < (3/3) |
| BK:
Thanks for all the input. I sorta combined a few ideas of mine and your advice. First I made a small face plate to hold in the 3 jaw, it's rough but true, and I marked #1 jaw position on the shaft. Then a block of pine, the work piece and a largish washer. I put my cross slide stop on and set it to the diameter I needed. I then attacked it with this little tool, which I seem to use a lot. That worked well and I soon had a nice circle.I drilled 2 more holes and bolted the lot together.(and forgot to take a photo :bang:) I could then remove the centre bolt and finish the job with my holesaw. Now a bit of a rub on the wire wheel and I have 1 ring, 7 to go. :) Thanks. |
| sbwhart:
:mmr: Well sorted Nice bit of work Stew |
| Dean W:
That's one skinned cat. Good advise in this thread. Dean |
| Brass_Machine:
Interesting technique! great results.. gonna file this one for future use! Thanks Eric |
| Navigation |
| Message Index |
| Previous page |